Creating IAT - Image on instructions
Hello Gurus,
I am stumped again :-). I created instructions on a sketchpad, yet designed the directions as a png file. When I run the experiment, the instructions show after every keypress, not sure what to place in "Show if". Thoughts?
I created the image for the directions as I wanted the alignment to be different than what I could do in OpenSesame.
Thank you.
Jason
Comments
Hi @jdmill51,
It sounds as if you included your instructions within the trial sequence instead of before the loop. To present the instructions once and then run the block of trials, place the instructions before the loop containing your list of trials.
Best,
Fabrice.
Thank you Fabrice!