My latest adventure (I'm probably becoming a bit of a pest at this point!) in OpenSesame is an attempt to create a staircase loop. I've found the following discussion:
and planned to contact the original poster to ascertain if they were successful in implementing the loop but I cannot locate any contact details.
I hope to create a loop where I'll have up to 8 different display timings for a sketchpad (same stimuli each time) and be able to drop out of the loop once a participant reaches approx. 75% accuracy on one of those timings and then run a sequence for the actual experiment using said timing.
Has anyone here successfully achieved anything similar?
Advice would be most welcome as I've managed to build an experiment just fine for an undergrad but this addition would make it more elegant and the student is keen to get started.