eego AntNeuro
Hi all,
Using MATLAB and RPvdsEx program, I am sending a trigger to a TDT RZ6 which then simultaneously sends a trigger to the eego Antneuro sport and a sound through headphones. The eego, however, shows the trigger after significant delay, approximately 1.5 seconds, relative to the sound. However, when I used the oscilloscope to observe the trigger and sound signals from RZ6 directly, I found the sound is delayed approximately 75 milliseconds.
I have been at struggling with this problem for a while now and would greatly appreciate any suggestions on how to solve/troubleshoot it!
Thanks,
Mohamed
Comments
Hi Mohamed,
You've posted this question in the OpenSesame support forum. But it sounds like you're actually Matlab, and not OpenSesame? Is that correct? In that case, I'll move this discussion to the Miscellaneous category.
Also, the way you phrased your question, I think it will be very difficult to understand except for someone who is familiar with all the of the software and devices that you're mentioning. And since you mention quite a few (Matlabl, RPvsdEx, TDT RZ6, Eego), the chance of finding someone like that may be small! Maybe you can describe in a bit more detail, and without assuming too much experience with these devices, what the problem is that you're running into?
Cheers,
Sebastiaan
Check out SigmundAI.eu for our OpenSesame AI assistant!