[open] keypress problem

Comments

• Wouter

  December 2012 edited 2:42PM

  Hi Cumhur,

  Step 2: Present response/answer screen - keypress function (stechpad)

  Do you mean that you have a sketchpad-item, and have set the duration to keypress ? If so, then that's probably your problem: your first keypress is used to continue from this sketchpad, and your 2nd keypress is then caught by the keyboard_response item.

  If you set the duration of this sketchpad to 0, the experiment will show the response/answer screen, and will immediately advance to the keyboard_response item which collects the response for the logger.

  Hope this helps,

  Wouter
• miran

  December 2012 edited 2:42PM

  Yeap I realized that it was my mistake, after reading through the tutorials again. Many thanks for the swift response.

  Best

  Cumhur
• Catriona

  February 2015 edited 2:42PM

  Hi there,

  I am having a similiar problem as above. After showing a sketchpad item, the response in keyboard response has to be pressed twice. However, this only happens after each response has already been pressed at least once (M or Z).

  My sketchpad duration is 0 and I have enabled flush pending keypresses.

  Are there any other solutions?

  Cheers,
  Catriona
• eduard

  February 2015 edited 2:42PM

  Hi Catriona,

  would you mind uploading the experiment, so that I could have a look on it?

  Thanks,

  Eduard

  
• Catriona

  February 2015 edited 2:42PM

  https://www.dropbox.com/s/b5q9dkzf55elmxw/PL1.opensesame.tar.gz.opensesame.tar.opensesame.tar.gz?dl=0

  Not sure if this is the best way to send it over. Let me know if it doesn't work, I'm not so hopeful. I've had problems transferring it over to other computers.
• eduard

  February 2015 edited 2:42PM

  Hi Catriona,

  Which version of OpenSesame are you running?

  I just tested your experiment with mine (2.9.4) and it worked like you want it to. So, only one keypress required to make the sketchpad disappear and start the recording phase.

  Eduard